|
Digital signals are transmitted from the satellites on either Vertical (V) or
Horizontal (H) polarity for linear feeds, or on Right (R) and Left (L) polarity for
circular feeds. Standard big dishes are most likely to have feed horn that can
receive linear (H/V) polarity. Other system such as Dish Network and Direct TV use
circular polarity.
If you have a big dish, most manufacturer of feed horns such as Chaparral and ADL provide
what is called a "Teflon Slab" that can be added to the feed horn which would
allow it to receive both linear and circular polarity signals. This will cause a loss of
about 1 dB in signal level on the linear polarity signals. A Wideband Chaparral
feed horn can receive both linear and circular (Ku band) polarity signals.
In order to receive the digital TV signal, you must have the feed horn set to
the correct polarity. For LNBFs, the polarity is controlled automatically by a
voltage transmitted form the receiver to the LNBF via the coax cable. The receiver
will send the LNBF 18 volts for horizontal polarity, and 13 volts for vertical polarity.
For standard LNBs, the polarity is controlled by a motorized motor. In this case,
odd channels represent one polarity, and even channels represent the other polarity.
Standard satellites have the even channels set the
polarizer to horizontal
polarity, and the odd channels set it to vertical polarity. If the Satellite
Polarity is inverse, then the even channel set it to the vertical polarity, and the odd
channels set it to the horizontal polarity. Furthermore, some LNBFs such
as Dishnetwork's DP LNBFs control the polarity change by shifting the frequency
rather than using 13/18 volts. In fact the new shifted horizontal polarity
is 25600 minus the original horizontal polarity.
If you are unsure of which channel represents which polarity, simply set the digital
receiver to display the signal strength meter, then switching between odd and even
channels on the analog receiver will generate a marked difference in signal strength.
Polarity can also play an important role in whether you are able to receive the
digital signal at all. Digital signals are not as forgiving as analog signals, it is
either you receive it or you do not. If the signal meter shows a high signal (over 85% on
the Sat Cruiser), and you are still unable to receive the digital signal, then adjusting
the SKEW will almost always help.
Most analog receivers have auto tune feature, it will automatically find the
best dish position and the best polarity for the analog signal. Be forewarned that this is
not always the best setting for digital signals. However, in most cases it does produce
the best setting for the reception of digital signals.
If you are able to receive only the odd or even channels on a given satellite,
then your
polarizer is defective and need replacement. The
polarizer is a motor located on
your feedhorn which switches the unit to receive the vertical or the horizontal polarity.
Since every time you switch channels the motor moves, eventually it will wear out and will
need replacement. It is connected by three wires from the back of your analog
receiver to the dish (the wires are normally (Red '5VDC', White 'pulse', and Black
'ground'). Before replacing the
polarizer make sure to turn the receiver's power off. It
would be prudent to remove the power cable from the electric socket since most receivers
continue to provide power to the dish even when the unit is off.
|
